• South Pacific Falco Forum

George's Aeroplane

The story of Falco #1230 in Auckland
New Zealand
Main Menu
  • Home
  • People Falcoing
  • South Pacific Falcos
  • Flying Visits
  • Videos
  • My Hangar
  • Parakai Airfield
  • Guestbook
Building ZK-SMR
  • Kits and Tools
  • Wood Parts
  • Spars
  • Tail Parts
  • Fuselage
  • Wing Frame
  • Flaps and Ailerons
  • Wing Skins
  • Undercarriage
  • Canopy
  • Panel
  • Electrical
  • Interior
  • Engine
  • Fuel System
  • Miscellaneous
  • Fill, Sand, Paint
  • Flight Testing
Resources
  • Web Links
  • Old FBL's
  • NotiFly

Wing Skins

postdateiconTuesday, 11 September 2007 09:00 | postauthoriconWritten by Administrator | PDF | Print | E-mail

I was going to just continue the 'Wings" section but then I realised that there was so many different ways of doing this and for such a big deal was made of the whole thing in all the builders letters that I thought I would show how I did it..


Firstly I must admit that I too was a little concerned of how to do this since I'd seen so much written about it however I can now say to any current or prospective builder... DON'T PANIC !! its a hell of a lot easier that people make out.. the following is how I did it and I must say that with the exception of needing a little patience, it is one of the easier parts.

The boiling tank in action

This is my boiling tank in action on a wing skin.... Try making one of these suckers without any leaks !!


I'm not sure I would bother if I did it again but it was fun anyhow.

The 2.5mm skins take about 3 hours and the 1.5 about 20 min.

I must confess that this system didn't really work for me. I ended up using a clothes iron and a wet cloth to bend the skin around the former. That worked great for me and was relatively quick. About 1 hour for the thickest skins.

Steam.. bend a bit.. steam .. bend a bit and so on... easy!


Bending the leading edge

Bending the skins around a former is fun... I was very worried about this part since there is so much written about it. I found it very easy and all that was required was a bit of patience since it takes about 1 hour to steam and bend the 2.5mm around a 30mm former. After letting dry for 3-4 days the skin fits perfectly and I didn't need any fancy clamping structures for the rear skins, mainly just staples.

The second skin being fitted

PROOF !! here is the second skin (First is the bottom) before I glued it on... no clamps (except the two at the top stopping it hitting the floor) .. it just snaps around the leading edge..... easy !!

No glue yet !!

Another view before gluing... I scarf later around the leading edge..


Excuse the mess - I'll clean up when I've finished skinning !!

A quick test fly around the yard

Wing, Wing..... Hello ??

 


With both wings complete I just couldn't resist taking it out to see what it looked like before turning it upside down to finish the bottom.


Now on to filling and sanding the damn thing !!

 

Copyright © 2010 ---.
All Rights Reserved.

Designed by TeLoad.com.